EIGRP MINI LAB

Objective:

1) Configure EIGRP 100 on R1, R2, R3, R5, R6 and R7 on required interface using the wild card mask.
2) EIGRP should not send hello packets on interface where routers are not connected
3) External routes should be sent as summary routes in the internal EIGRP network
4) ISP routes should not be advertise in the EIGRP Network but EIGRP routers should ping ISP routes
5) R7 loopback interface should not be advertised in EIGRP using network command but other EIGRP routers should know about that loopback network.
6) Configure authentication between R7--R2 and R3---ISP routers
7) Isp should not loop the packet in the network
8) Configure R6 as stub router. It should only receive routes
9) Bandwidth on the interface of R2 router which is connected to r3 should be 1000Kbit and R2 should do unequal cost load balancing to reach the 10.1.3.0/24 network.

10) For the lab, try to use the minimum commands as possible